Daytime Fan-Aspirated Radiation Shield Kit Installation Manual

More documents

Recommendations

Info

Installing the Daytime Fan Kit20. Insert one of the 3 1/4'' screws and corresponding lock and flat washersincluded in the kit hardware into the ISS baseRadiation Shield Mounting Holes (3)Radiation Shield Mounting Holes in ISS base12
21. Lower the ISS baseonto the stack so thatthe screw goes into theboss. Turn the screw afew times to engagethe threads.22. Place a lock washerand flat washer on theother two 3 1/4''screws then insertthem through the othertwo screw holes.23. Tighten all threescrews to securelyfasten the radiationshield to the ISS base.Re-Install the ISS1. Install the raincollector cone and lockit in place.2. Slide theTemperature/Humiditycable and thefan-aspirated unit’ssolar power cableassembly through thecable access port of theSIM box.3. Connect theTemperature/Humiditysensor cable.#8-32 x3-1/4" Screws (3)#8 Lock Washers#8 Flat WashersTemperature/HumidityCablePower CableAssemblyInstalling the Daytime Fan KitInsert front screwfirstSIM HousingISS BaseClosed Cap PlateOpen Cap Plate(hole in center)Fan PlateReconnecting the Radiation Shield to theRain Collector4. Close the SIM cover temporarily without connecting the solar panelcables.5. Test communication between the ISS and the console. To testcommunication, take the console out of Setup Mode and make sure theconsole is receiving data from the ISS. See the ISS manual for moreinformation on testing communication.6. Reinstall the ISS in its previous location.7. Open the SIM cover and connect the WIND (anemometer) cable.8. Cabled ISS Only: Connect the console cable.13
Page 4: Installing the Daytime Fan Kit3. Re
Page 7: Installing the Daytime Fan Kit5. Pu
Page 10 and 11: Installing the Daytime Fan Kit11. B
Page 14 and 15: Installing the Daytime Fan Kit9. Co

Daytime Fan-Aspirated Radiation Shield Kit Installation Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?