CSVB Series II - Columbia Heating

STARTING YOUR BOILER! WARNINGIf you do not follow these instructionsexactly, a fire or explosion may resultcausing property damage, personal injuryor loss of life.• This appliance is equipped with an ignition devicewhich automatically lights burner. Do NOT try tolight this burner by hand.• Before operating smell all around appliance areafor gas. Be sure to smell next to floor becausesome gas is heavier than air and will settle to thefloor.• Use only your hand to turn the gas shutoffvalve. Never use tools. If valve will not turn byhand, do not try to repair it, call a qualified servicetechnician. Force or attempted repair mayresult in fire or explosion.• Do not use this appliance if any part hasbeen under water. Immediately call a qualifiedservice technician to inspect appliance and toreplace any part of control system and any gascontrol which has been under water.LIGHTING PROCEDURE FOR BOILER WITHINTERMITTENT PILOT SYSTEMFor Your Safety, Read Before Operating!!A. This appliance is equipped with an ignition devicewhich automatically lights the pilot. Do not try to lightappliance by hand.! CAUTIONWHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electrical switches; do not useany phone in your building.• Immediately call your gas supplier from aneighbor’s phone. Follow the gas supplier’sinstructions.Operating Instructions.1. STOP! Read Safety Information on previous page.2. Set the thermostat to lowest setting.3. Turn off all electric power to the appliance.4. This appliance is equipped with an ignition device whichautomatically lights the burner. Do not attempt to lightpilot by hand.5. Remove burner access panel.Figure 13INLET- Gas Control KnobGAS CONTROL KNOBSHOWN IN "ON" POSITION6. Depress gas control knob slightly and turn clockwiseto “OFF” position.7. Wait five (5) minutes to clear out any gas. If you thensmell gas STOP! Follow WHAT TO DO IF YOU SMELLGAS. If you don’t smell gas, go to next step.8. Turn gas control knob counterclockwise to “ON.”9. Turn on all electric power to the appliance.10. Set thermostat to desired setting.11. After visually inspecting the flame, replace lower frontpanel.12. If appliance will not operate after several tries, turn gascontrol knob to “OFF” and call your service technicianor gas supplier.To Turn Off Gas To The Appliance1. Set the thermostat to lowest setting.2. Turn off all electric power to the appliance if servicing isto be performed.3. Depress gas control knob slightly and turn clockwiseto “OFF” position. Do not force.OFFON• If you cannot reach your gas supplier, call the firedepartment.25