EP9648-00- Prospekt - Martens Elektronik GmbH

More documents

Recommendations

Info

Connection diagram0 ... 10 V DC0/4 ... 20 mAAnalog output0 ... 10 V DC/5 mASupply voltageDimensionsSealPanel cut-outacc. to DIN 437<strong>00</strong>-96x48- 2 -
Displays and controlsField for unitUp buttonDown buttonPhoto sensorParameter buttonDescriptionAfter switching on the supply voltage, the device initializes itself. The display shows the message .After the initializing procedure the device is located in the Working level.Activating the button for more than 2 seconds, the program is located in the Configuration level.Selection within a parameter or entering data, use buttons and . To change the selected parameterpress button again. Setting of the value or selection with button and . Entering data with button .After finishing the configuration or when longer than 2 minutes no button was pushed, the program jumps backto the working level. Leaving the configuration level is possible at any time by pushing the button for 2 seconds.Error codesDisplay flashes input signal is more than 3% outside of the programmed measurement rangeplease ship the panelmeter to factory for repair service. Program lockout. See configuration page 4.Start-up note:Before the device can be used, it must be configurated for the intended use.Please note:All parameters can be called if they are not blocked by other programmed parameters andif they are available. Factory settings are shown in the display graphic.Parameter is only displayed if included (see order code)ConfigurationButton Display DescriptionPress2 sec.Conversion ratePress button 8 measurements per second 2 measurements per second 0.5 measurements per secondSelection with button and . Entering with button .continuepage 4Input signalPress button, , , Selection with button and . Entering with button .- 3 -
Page 1: Economy Panelmeter EP 9648Industry

EP9648-00- Prospekt - Martens Elektronik GmbH

Create successful ePaper yourself

Delete template?

Save as template?