HFS-03 Lock Standard - saf-holland

More documents

Recommendations

Info

HFS-03 – SAF-HOLLAND Lock Standard Page 20 of 35Rev. K (6/11)APPENDIX B (cont.)Magnetic Particle Inspection shows surface and near to surface indications and because of this,NoLube coated locks can show weld passes that were laid down during the coating process.Acceptance criteria for NoLube coated locks (XA-10853-1, XA-10853-SP, XA-10486-E):Acceptable: Wavy, blurry indications of similar intensity (See figures below for examples).See next page for additional acceptance criteria for XA-10853-1 and XA-10853-SP.Unacceptable: A. Straight indications, B. indications that stand in sharp contrast (greaterintensity) to other indications in the lock surface or C. Edges of coating not cleaned upproperly.Applies to XA-10853-1, XA-10853-SP & XA-10486-EAcceptable:Wavy, blurryindications – nocracks. See alsonext page.Unacceptable:A. Straightindication –crack in coatingsurface. Seealso next page.Unacceptable: B. Indications standin sharp contrast (greater intensity)than others. See also next page.XA-10853-SPUnacceptable: C. Edges of coatingnot cleaned up properly. To besmooth with forged surface.XA-10486-E
HFS-03 – SAF-HOLLAND Lock Standard Page 21 of 35Rev. K (6/11)APPENDIX B (cont.)Applies to XA-10853-1 & XA-10853-SPAcceptable: Indications are in the coatingonly (don’t extend into the forging) and arewithin the 70° or 25° areas.Unacceptable: Indications in the 85° area.
Page 1 and 2: SAF-HOLLANDLock StandardHFS-03Rev.
Page 4 and 5: HFS-03 - SAF-HOLLAND Lock Standard

HFS-03 Lock Standard - saf-holland

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?