HFS-03 Lock Standard - saf-holland

HFS-03 – SAF-HOLLAND Lock Standard Page 20 of 35Rev. K (6/11)APPENDIX B (cont.)Magnetic Particle Inspection shows surface and near to surface indications and because of this,NoLube coated locks can show weld passes that were laid down during the coating process.Acceptance criteria for NoLube coated locks (XA-10853-1, XA-10853-SP, XA-10486-E):Acceptable: Wavy, blurry indications of similar intensity (See figures below for examples).See next page for additional acceptance criteria for XA-10853-1 and XA-10853-SP.Unacceptable: A. Straight indications, B. indications that stand in sharp contrast (greaterintensity) to other indications in the lock surface or C. Edges of coating not cleaned upproperly.Applies to XA-10853-1, XA-10853-SP & XA-10486-EAcceptable:Wavy, blurryindications – nocracks. See alsonext page.Unacceptable:A. Straightindication –crack in coatingsurface. Seealso next page.Unacceptable: B. Indications standin sharp contrast (greater intensity)than others. See also next page.XA-10853-SPUnacceptable: C. Edges of coatingnot cleaned up properly. To besmooth with forged surface.XA-10486-E