Operating Instructions 150 000 019 00 EN

7.3 Wheel guards• For all service, maintenance, repair and assembly work on the rotary tedder, alwaysswitch off the PTO shaft.• Switch off the engine and remove the ignition key.• Protect the tractor and rotary tedder from rolling!• The raised rotary tedder must be prevented from accidentally being lowered!A wheel guard is available for the middle wheels. Thewheel guard kit consists of:- Wheel cover (4) with screw-on clip (2) and distanceplate (3)- Two M 10 hexagonal bolts with spring washers (1)- M 8 clamp screw with washer and nut (5)- Anti-winding disc (6)- Guard extension (7) with reinforcement strip (8) andthree M 6 flat round screws with washers and nuts (9)891572346KW-0-022To mount the wheel guards, lift the rotary tedder.Dismantle the wheel bracket (2). To do so, pull out thelinch pin (1) and remove the wheel bracket and wheelfrom the rotary tedder.1 2KW-0-021The anti-winding pot (2) is replaced by the anti-windingdisc (3). To do so, take the wheel (4) off the wheelbracket (1) by dismantling the hub cap and releasingand unscrewing the self-locking nut. Take the wheel offthe wheel bracket. Then remove the anti-winding pot.Push the anti-winding disc onto the wheel bracket.Assemble the wheel in the opposite order.1 234KW-0-02433