Operating Instructions 150 000 019 00 EN

More documents

Recommendations

Info

3.5 Edge spreading mechanismThe undercarriage wheel setting can be seen on thepointer (1). It is situated to the right of the carrier bar inforward direction.To keep the load on the running wheelsas low as possible, avoid cornering tootightly when boundary spreading is set.1KW-0-035To adjust the edge spreading mechanism, raise therotary tredder. Switch the hydraulic switchover valve (1)to position "b" (edge spreading mechanism). The edgespreading mechanism can be adjusted from the controlvalve on the tractor. The setting of the undercarriagewheels can be seen on the pointer.1abKW-0-0483.6 StabilizersFor rotary tedders with a large working width, themachine could start to wobble on uneven ground. Agreater pre-tensioning of the stabilizers can suppressthis effect. To achieve this, tighten the screws (1) of thefriction plates (2) on the stabilizer tubes (3).1Do not tighten the friction plates tootightly, or the stabilizers may lock!23KW-0-02622
3.7 Tine adjustmentThe tines (3) must be aligned vertically to the ground.The alignment of the tines can be changed by turningthe eccentric. For adjustment release securing bolt (1)and turn eccentric (2) to the next position. Tighten theadjustment screw to a torque setting of 95 Nm.2190°3KW-1-05823
Page 1 and 2: Rotary tedderKW 5.50 / 4 x 7KW 6.70
Page 3 and 4: I. ForewordDear customer,Ordering R
Page 5 and 6: III. General1. Operation in Accorda
Page 7 and 8: 5. Hydraulic System1. The hydraulic
Page 9 and 10: 1Do not exceed themaximum permitted
Page 11 and 12: 1440 135-3 (1x) bei KW 5.50939 429-
Page 13 and 14: 2. Preparations for use2.1. Special
Page 15 and 16: PTO shaftAfter the rotary tedder ha
Page 17 and 18: 2.4 Adjusting the PTO shaft length
Page 19 and 20: 2.7 Conversion from working totrans
Page 21 and 22: Switch off the engine and remove th
Page 23: 3.3 Drive rpmsWide spreading (teddi
Page 27 and 28: 4.3 HydraulicsThe rotary tedder has
Page 29 and 30: Lubrication points on the KW 6.70 /
Page 31 and 32: 5. Winter storage5.1 Safety instruc
Page 33 and 34: 7. Special accessories7.1 Night swa
Page 35 and 36: 7.3 Wheel guards• For all service
Page 37: 7.4 Fixed lightingA permanently fix
Page 40 and 41: 1. Special safety instructions• P
Page 42 and 43: 4. Mounting the disc arms to the di
Page 44 and 45: Bolt the front protective frame (2)
Page 46 and 47: 5.3 Mounting of the protective fram
Page 48: KW 6.70/6, KW 7.70/6x7 and KW 8.80/

Operating Instructions 150 000 019 00 EN

Create successful ePaper yourself

Delete template?

Save as template?