Operating Instructions 150 000 019 00 EN

Mounting the PTO shaft on the rotarytedderKW 5.50 / 4x7 and KW 6.70 / 612Only those PTO shafts provided may bemounted and used.To mount the PTO shaft on the rotary tedder, unscrewthe screw (1) on the rotary shaft protective sleeve (2),twist the protective socket and the protective tubeagainst each other and push the PTO shaft protectivesleeve in the direction of the arrow.Push the PTO shaft with the overload clutch onto thePTO shaft end on the rotary tedder. Take care toensure that the locking device (1) clicks into place. Fitthe protective sleeve again and secure it with a screw.Note direction of arrow on PTO shaft!KW-0-0381KW 7.70 / 6x7 and KW 8.80 / 8The PTO shaft is fitted with the friction/free runningcoupling facing the rotary tedder. The disassembly ofthe PTO shaft protective sleeve is not necessary here.Make sure that the locking device clicks into place.Vent the overload coupling beforecommissioning.(see chapter 6.1)KW-0-0392.3 Attaching the rotary tedder to thetractor• When fitting the rotary tedder, makesure that nobody enters the areabetween the implement and thetractor.• Make sure that the tractor frontwheels remain on the ground whenthe rotary tedder is raised. Ifnecessary, raise the ballast on thefront axle.2Couple the rotary tedder to the lower link arm (1) andupper link arm (2). Fix the lower link arms to the tractoruse limiting chains or rods so that the rotary tedderdoes not swivel out to the side.1KW-0-008The withdrawal speed of the rearhydraulic system must be reduced byadjusting the lowering throttle so thatthe undercarriage of the rotary tedder isslowly lowered to the ground.12