Piper J-3 Cub - Hangar 9
Piper J-3 Cub - Hangar 9
Piper J-3 Cub - Hangar 9
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 1: Hinge Installation Step 11Cut a groove from the hole to the bottom of the rudder toallow clearance for the tail gear bearing. Step 13Cut a slot in the end of the fuselage to accept the tailgear bearing. Step 12Apply a thin layer of lubricant where the bearing willride in the rudder. Use 30-minute epoxy to glue the wireinto the rudder. Step 14Install three hinges into the rudder. Test fit the rudderto the fuselage, sliding the hinges and tail wheel bracketinto position. Step 15Use 30-minute epoxy to glue the tail gear bearing into thefuselage. Use thin CA for the hinges.10