1 - Al Kossow's Bitsavers

SMJ251616,384-B11 ERASABLE PROGRAMMABLE READ-ONLY MEMORIESrecommended operating conditionsPARAMETERSMJ2516-35SMJ2516-45MIN, NOM MAX MIN NOM MAXSupply voltage, VCC (see Note 2) 4.5 5 5.5 4.5 5 5.5 VSupply voltage, Vpp (see Note 3) Vec Vee VSupply voltage, VSS 0 0 VHigh-level input voltage, VIH 2 VCC+ 1 2 VCC+ 1 VLow-level input voltage, VIL -0.1 0.8 -0.1 0.8 VRead cycle time, tc(rd) 350 450 nsOperating case temperature, T C -55 125 -55 125 °cUNITNOTES:2. Vee must be applied before or at the same time as Vpp and removed after or at the same time as Vpp. The device must not be inserted intoor removed from the board when Vpp or Vee is applied.3. Vpp can be connected to Vee directly (except in the program mode). Vee supply current in this case would be ICC + Ipp. During programming.Vpp must be maintained at 25 V (± 1 V).electrical characteristics over full ranges of recommended operating conditionsocPARAMETERVOH High-level output voltageVOL Low-level output voltageII Input current (leakage)10 Output current (leakage)IpP1 Vpp supply currentVpp supply currentIpP2(during program pulse)VCC supply currentICC1(standby)m""CVCC supply current:lJICC2(active)3!: t Typical values are at Te = 25°C and nominal voltages.TEST CONDITIONS10H = -400/LAIOL = 2.1 mAVI = 0 V to 5.5 VVo = 0.4 V to 5.5 VVpp = 5.25 V, PD/PGM = VILPD/PGM = VIHPD/PGM = VIHS = PDIPGM = VILSMJ2516MIN Typt MAX2.40.45±10±1063020 3057 100~ capacitance over recommended supply voltage arid operating case temperature ranges, f 1 MHzt(i'CD(I)PARAMETERTEST CONDITIONSCi Input capacitance VI = 0 V, f = 1 MHzCo Output capacitance Vo = 0 V, f = 1 MHzSMJ2516TYP:t MAX4 68 12UNITVV/LA/LAmArnAmAmAUNITpFpFt Capacitance measurements are made on a sample basis only.* Typical values are at T e = 25°C and nominal voltages.6-6TEXASINSTRUMENTSPOST OFFICE BOX 225012 • DALLAS, TEXAS 7526518