NXAMP4x1 & NXAMP4x4 User Manual - Nexo

QUICK START(7) Rear end mounting holesBasic functionsIf the NXAMP is to be rack mounted and transported frequently, be sure to support therear end of the unit with mounting hardware that matches the size of the rack used.ResetYou can reset the unit without powering off by simultaneously depressing buttons A, B &“Select CH1” for 3 seconds at least.0. FLAT - NO PROTN.[4 ch amplifier] ~~Selecting cabinet family(For 3 seconds)Simultaneously depressing A & B buttons at power up or during device RESET accesses thesystem change menu. Keep the A & B Buttons held until Load revision disappears fromscreen (approx. 2 seconds). This will allow the selection of any cabinet in any family. Usingthe rotary encoder, scroll through the configurations and press “B” to load the requiredsettings.42. GeoD PA WBBack1-3 Front2-4~~OKSelect your cabinet set-upIn the ‘Options’ menu, choose “Systm Config”, and you will be able to choose among thedifferent set-ups within the same cabinet family. (i.e. you don't have to modify theamplifier to cabinet wiring).PAGE 18 OF 103