WSM User Guide - WatchGuard Technologies

Using BGPSection Command DescriptionPeer FilteringRedistribute Routes to BGPip community-list [|] permit AA:NNneighbor [A.B.C.D] distribute-list [LISTNAME] [IN|OUT]neighbor [A.B.C.D] prefix-list [LISTNAME] [IN|OUT]neighbor [A.B.C.D] filter-list [LISTNAME] [IN|OUT]neighbor [A.B.C.D] route-map [MAPNAME] [IN|OUT]redistribute kernelredistribute ripredistribute ospfRoute Reflectionbgp cluster-id A.B.C.DAccess Lists and IP Prefix Listsneighbor [W.X.Y.Z] route-reflector-clientip prefix-list PRELIST permit A.B.C.D/Eaccess-list NAME [deny|allow] A.B.C.D/Eroute-map [MAPNAME] permit [N]match ip address prefix-list [LISTNAME]set community [A:B]match community [N]set local-preference [N]Specify community to acceptautonomous system number andnetwork number separated by acolonSet distribute list and direction forpeerTo apply a prefix list to be matchedto incoming advertisements oroutgoing advertisements to thatneighborTo match an autonomous systempath access list to incoming routesor outgoing routesTo apply a route map to incomingor outgoing routesRedistribute static routes to BGPRedistribute RIP routes to BGPRedistribute OSPF routes to BGPTo configure the cluster ID if theBGP cluster has more than oneroute reflectorTo configure the router as a BGProute reflector and configure thespecified neighbor as its clientSet prefix listSet access listIn conjunction with the “match”and “set” commands, this definesthe conditions and actions forredistributing routesMatches the specified access_listSet the BGP community attributeMatches the specifiedcommunity_listSets the preference value for theautonomous system pathUser Guide 339