WSM User Guide - WatchGuard Technologies

Using RIPSection Command DescriptionSet simple password or MD5 authentication on an interfaceinterface eth[N]ip rip authentication string [PASSWORD]key chain [KEY-CHAIN]key [INTEGER]key-string [AUTH-KEY]interface eth[N]ip rip authentication mode md5ip rip authentication mode key-chain [KEY-CHAIN]Configure RIP routing daemonBegin section to set authenticationtype for interfaceSet RIP authentication passwordSet MD5 key chain nameSet MD5 key numberSet MD5 authentication keyBegin section to set authenticationtype for interfaceUse MD5 authenticationSet MD5 authentication key-chainrouter ripEnable RIP daemonversion [1|2]Set RIP version to 1 or 2 (defaultversion 2)ip rip send version [1|2] Set RIP to send version 1 or 2ip rip receive version [1|2] Set RIP to receive version 1 or 2no ip split-horizonDisable split-horizon; enabled bydefaultConfigure interfaces and networksno network eth[N]passive-interface eth[N]passive-interface defaultnetwork [A.B.C.D/M]neighbor [A.B.C.D/M]Distribute routes to RIP peers and inject OSPF or BGP routes to RIP routing tabledefault-information originateredistribute kernelredistribute connectedredistribute connected routemap[MAPNAME]redistribute ospfredistribute ospf route-map[MAPNAME]redistribute bgpredistribute bgp route-map [MAPNAME]Configure route redistribution filters with route maps and access listsShare route of last resort (defaultroute) with RIP peersRedistribute firewall static routes toRIP peersRedistribute routes from allinterfaces to RIP peersRedistribute routes from allinterfaces to RIP peers, with a routemap filter (mapname)Redistribute routes from OSPF toRIPRedistribute routes from OSPF toRIP, with a route map filter(mapname)Redistribute routes from BGP to RIPRedistribute routes from BGP to RIP,with a route map filter (mapname)User Guide 327