WSM User Guide - WatchGuard Technologies

Adding New Users to the PPTP_Users Authentication Group2 From the Choose Type drop-down list, select Host IP (for a single IP address) or Host Range (for arange of IP addresses).You can configure 50 addresses. If you select Host IP, you must add at least two IP addresses. If you select HostRange and add a range of IP addresses that is larger than 50 addresses, RUVPN with PPTP uses the first 50addresses in the range.3 In the Value text box, type the host IP address. If you selected Host Range, type the first and last IPaddress in the range. Click OK.Type IP addresses that are not in use that the Firebox can give to clients during RUVPN with PPTP sessions. The IPaddress appears in the list of addresses available to remote clients.4 Do the procedure again to configure all the addresses for use with RUVPN with PPTP.Adding New Users to the PPTP_Users Authentication GroupTo create a PPTP VPN tunnel with the Firebox®, a remote user types their user name and password toauthenticate. WatchGuard® System Manager software uses this information to authenticate the user tothe Firebox.When you enable PPTP in your Firebox configuration, a default user group is created automatically. Thisuser group is called pptp_users. You see this group name when you create a new user or add usernames to policies.For more information on Firebox groups, see “Implementing Authentication,” on page 121.1 From Policy Manager, click Setup > Authentication Servers.The Authentication Servers dialog box appears.2 Click the Firebox tab.282 WatchGuard System Manager