WSM User Guide - WatchGuard Technologies

Working with Devices on a Management Server7 Use the instructions on the Wait for the Firebox and The Wizard found this Firebox pages. ClickNext after each page.8 Accept the License Agreement and click Next.9 Configure the external (WAN 1) interface of the Firebox X Edge. Select DHCP, PPPoE, or Static IPaddressing, and click Next. (For detailed information on how to configure the Edge interfaces, seethe Firebox X Edge User Guide.)10 Click Next after you configure the interface.11 Configure the Edge internal interface and click Next.12 Create a status passphrase and a configuration passphrase for your Edge and click Next.You must type each passphrase two times. This is the passphrase that is used by WatchGuard System Manager toconnect to and configure the device.13 Type a user name and passphrase for the device, and click Next.You must type the passphrase two times. This is the user name and passphrase that you can use to connect to andconfigure the device with a web browser.14 Select the time zone settings and click Next.15 Configure the Management Server settings. Type the IP address of the gateway Firebox thatprotects the Management Server, the name to identify the Firebox in the Management Serverinterface, and the shared key. Click Next.The shared key is used by the Management Server to create VPN tunnels between Fireboxes. You do not have toremember this key.16 Review the configuration for the Edge and click Next.17 To set up another Edge, select the check box. Click Finish.If you select this check box, the Quick Setup Wizard populates the fields with the same values as thisconfiguration, so you can easily set up similar Edge devices.Importing Firebox X Edge devices into a Management ServerFirebox X Edge devices that are configured with the Quick Setup Wizard can be imported into the ManagementServer.1 Start WatchGuard System Manager, and connect to the Management Server for which youconfigured Edge devices.2 Select File > Import Device.The Import Device dialog box appears.3 Select the check boxes in front of each Edge you want to import. Click Import.The Firebox X Edge devices are imported into the Management Server. The devices appear in theImported Devices folder for the Management Server.Preparing an installed Firebox X Edge for management1 Start your web browser. Type the IP address of the Firebox X Edge.2 Type a user name and passphrase to log on to the Edge, if required.User Guide 255