WSM User Guide - WatchGuard Technologies

Setting Report Properties9 Type the Firebox® IP address or host name. Click Add.When you type the IP addresses, type all the numbers and the periods. Do not use the TAB or the arrow key. Whenyou create a report with consolidated sections, you must use only WFS Fireboxes or Fireboxes using Fireware®.If you use the two Firebox versions in a report the results are not correct.10 Use the other tabs to set the report preferences. You can find information about this in subsequentsections of this chapter.11 Complete the report configuration. Click OK.The name of the report appears in the list of the reports.Editing an existing reportYou can change the definition of a report.1 From Historical Reports, select the report to change. Click Edit.The Report Properties dialog box appears.2 Change the report definition.To see the function of an item, right-click it, and then click What’s This?.Deleting a reportYou can remove a report from the list of available reports.From Historical Reports, select the report to change. Click Remove. This removes the .rep file from the report-defs directory.Viewing the reports listTo see all the reports, click Reports Page. The reports appear in your default browser. You can movethrough all the reports in the list.Backing up report definition filesReport definition files contain the settings for the reports you create. It is a good idea to create regular,frequent backup files of your report definition files. This can save you time later if you want to move yourLog Server to a different computer. To create a backup file of your report definitions, copy the contentsof the \Documents and Settings\WatchGuard\report-defs folder to an archive file. Keep it in a safe place.Setting Report PropertiesYou use the Report Properties dialog box to configure many properties of reports. To see this dialogbox:• Select a report in Historical Reports and click Edit.or• In Historical Reports, click Add.Specifying a report time intervalWhen you create a report, the report includes data from the full log file, unless you change the timeinterval. On the Time Filters dialog box, use the drop-down list to select a time interval, for exampleUser Guide 187