WSM User Guide - WatchGuard Technologies

Configuring Policy Properties- ESP- ICMP- IGMP- OSPF- IP- AnyWhen you select Port Range, you can select TCP or UDP.9 From the Server Port drop-down list, select the port for this new policy. If you selected Port Range,select a starting server port and an ending server port.10 Click OK.Policy Manager adds the values to the New Policy Template dialog box. Make sure that the name, information, andconfiguration of this policy are correct. If necessary, click Add to configure more ports for this policy. Do the AddPort procedure again until you configure all ports for the policy.11 Click OK.The Add Policy dialog box appears with the new policy in the Custom folder.Adding more than one policy of the same typeIf your security policy lets you, you can add the same policy more than one time. For example, you canset a limit on web access for most users, while you give full web access to your management. To do this,you make two different policies with different properties for outgoing traffic:1 Add the first policy.2 Change the name of the policy to give the function in your security policy and add the relatedinformation.In this example, you can name the first policy “restricted_web_access.”3 Click OK. The Properties dialog box of the policy appears. Set the properties as shown in“Configuring Policy Properties” on page 150.4 Add the second policy.5 Click OK. The Properties dialog box of the policy appears. Set the properties.Deleting a policyAs your security policy changes, you sometimes have to remove one or more policies. To remove a policy,you first remove it from Policy Manager. Then you save the new configuration to the Firebox.1 From Policy Manager, click the policy.2 In Policy Manager, click the X button on the Policy Manager toolbar.You can also select Edit > Delete Policy.3 When asked to confirm, click Yes.4 Save the configuration to the Firebox and start the Firebox again. Select File > Save > To Firebox.Type the configuration passphrase. Select the Save to Firebox check box. Click Save.Configuring Policy PropertiesIf you added a policy and want to change its properties, double-click the policy icon to open the EditPolicy Properties dialog box.150 WatchGuard System Manager