Instruction Manual - Horizon Hobby

More documents

Recommendations

Info

Section 2: Installing the Main LandingGear/Wing Hold-Down DowelsWood Screw (4)Landing Gear Strap (2)Step 1Mount landing gear tofuselage with the twostraps and four screws.Step 2Step 1Locate the two landing gear wires, two nylon landing gear strapsand the four 3mm x 10mm sheet metal screws. The wheels havealready been installed for you. On the bottom of the fuselage, youwill find a groove with a hole near each side of the fuselage toaccept the landing gear wire. The landing gear wire slides into thehole and lies across the bottom of the fuselage. Install both landinggear wires.Step 2With the landing gear wires installed, secure them to the fuselageusing the two nylon landing gear straps and four 3mm x 10mmsheet metal screws. The straps lay across the wires and thescrews go into the predrilled holes on the bottom of the fuselage.Step 3Locate the two wing hold-down dowels and, using a twistingmotion, carefully insert one into each of the two holes located inthe fuselage. The dowels should be positioned so an equalamount protrudes from each side of the fuselage.6
Section 3: Installing the Tail AssemblyLocate the horizontal stabilizer and vertical stabilizer assemblies.The rudder and elevator have been prehinged at the factory, andthe control horns are also attached.Remove the shipping tape holding the rudder and elevator in place.Check both the rudder and elevator for freedom of movement.Step 1The vertical stabilizer has threaded rods in the bottom that secureit to the horizontal stabilizer. Insert the threaded rods through thepredrilled holes in the horizontal stabilizer. Secure them togetherusing two large washers and wing nuts. Be sure to use a drop ofthreadlock on the threaded rods before tightening the wing nuts.Step 2Slide the tail assembly into the slot in the rear of the fuselage,making sure the rudder pushrod is on top of the horizontalstabilizer. Use the two long screws and two small washers tosecure the tail assembly to the fuselage. There is a hole in thebottom of the fuselage to access the forward screw location. Placea drop of threadlock on the screws before installing them.Hint: Use a magnetic screwdriver when installing the screws.Long ScrewSmall WasherWing NutLarge WasherStep 2Step 1ThreadlockApply threadlock to thescrews before installing.VerticalStabilizerSlide tail assembly into theslot at the fuselage rear.<strong>Horizon</strong>tal StabilizerLargeWasherThreadlockWing NutApply threadlock tothe threaded rodsbefore installingthe wing nuts.Attach the vertical stabilizerto the horizontal stabilizerusing washer and wing nut.7
Page 2 and 3: Tape StripSection 1. Assemble WingS
Page 4 and 5: Table of ContentsAssembly Diagram .
Page 8 and 9: Section 3: Installing the Tail Asse
Page 10 and 11: Evolution Trainer Power SystemThe E
Page 12 and 13: Engine AdjustmentsModel engines run
Page 14 and 15: Glossary of Terms• Ailerons: Each
Page 16: TM®WE GET PEOPLE FLYING© 2003, Ho

Instruction Manual - Horizon Hobby

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?