ncr/doc/RealPOS/7460_RealPOS62/Technical_Manua...

Chapter 3: Installing an OS Using FitClient 3-5Preparing the ClientConnecting the Client to the Server1. Connect the client to the server network.2. Apply power to the client. The terminal automatically gets addedto the FitClient Default_Group. You can verify this by clicking onClients. The terminal’s Ethernet MAC address should bedisplayed.Note: The MAC address can be changed as desired in FitClientLoader.3. As the terminal boots it receives the 7454gho.bid bootstrap from theserver.4. Follow the DOS screen prompts. After each entry you are asked toconfirm your input. You can use 1 or y for Yes, 2 or n for No.5. Enter the Subnet Mask. This is blank if the DHCP Server providesit. (dots or spaces can be used as separators)6. Enter the Default Gateway. This is blank if the DHCP Serverprovides it. (dots or spaces can be used as separators)7. Enter the Computer Name of the local client.8. Enter the Workgroup. (if defined)Note: There should be a Workgroup or Domain defined, but notboth.9. Enter the Network Domain. (if defined)When the program has completed, you will receive a DOS prompt onthe client.This establishes communications between your server and theterminal. You can now access a shared drive or folder on the server byusing the net use command.