ARM DS-5 Using the Debug Hardware Configuration Utilities

Creating debug hardware target configurations5.32 Configuring a target processor for virtual EthernetFor applications on your target to communicate over your network, you must configure virtualEthernet on the target processor. This is required if the target does not have its own Ethernethardware, or if its drivers have not yet been written.NoteThe network settings are supported only on ARM7, ARM9, ARM11, and ARM SecurCoreprocessors using JTAG. They are not supported on CoreSight systems.To configure virtual Ethernet for a target processor:1. Open the Debug Hardware Config utility.2. Either:• connect to and configure a debug hardware connection to create a new debughardware configuration file• open an existing debug hardware configuration file.3. Connect to the required debug hardware unit.4. Select the Devices node in the tree diagram.5. Select the processor that want to configured for virtual Ethernet.6. Set the network settings as required. The following table shows an example:Table 5-1 Items for configuring static IP addressesDevice settingExampleIP Address 110.35.3.21Network Mask 255.255.255.0Default Gateway 110.35.3.2547. Select Save from the File menu to save the changes.8. Select Exit from the File menu to close the Debug Hardware Config utility.5.32.1 See alsoTasks• Creating a debug hardware configuration file on page 5-4• Connecting to a debug hardware unit on page 2-8• Disconnecting from a debug hardware unit on page 5-50.Reference• Debug hardware device configuration settings on page 5-26.ARM DUI 0498F Copyright © 2010-2012 ARM. All rights reserved. 5-51ID021112Non-Confidential