ARM DS-5 Using the Debug Hardware Configuration Utilities

Creating debug hardware target configurations5.25 Manually selecting a platformFor platforms that cannot be detected automatically, you can perform a manual selection froma list of supported platforms. To do this, click the Select Platform... button from the DebugSystem pane of the Debug Hardware Config utility, and the Select Platform dialog box displays.The following figure shows an example:Figure 5-15 List of supported platformsIn the Select Platform dialog box, select your platform and click OK. This causes the entireplatform configuration to be loaded, in a similar manner as when you are autodetecting aplatform.During the configuration process, the label on the Select Platform... button changes to read asClear Platform.You can also create your own platform files and add them to the list of available platforms.5.25.1 See alsoTasks• Autodetecting a platform on page 5-41• Clearing a platform assignment from a debug hardware configuration on page 5-44• Adding new platforms on page 5-45• Adding autoconfigure support for new platforms on page 5-46.Concepts• About platform detection and selection on page 5-40.ARM DUI 0498F Copyright © 2010-2012 ARM. All rights reserved. 5-43ID021112Non-Confidential