ARM DS-5 Using the Debug Hardware Configuration Utilities

Creating debug hardware target configurations5.13 Device Properties dialog boxThe Device Properties dialog box enables you to change the properties of any device in the scanchain, if required. The following figure shows an example:Figure 5-10 The Device Properties dialog boxYou can:• Select one or more options for the device. These options enable a debugger to determinethe features that are supported by a device. For example, a Registers view might show theNEON registers when the NEON SIMD Extensions (Neon) option is selected.• Set the template version for the device, if multiple versions are provided.If no properties are available for a device, the following message is displayed in the Options listNo device options found in current template5.13.1 Device propertiesThe device properties listed depends on the device being configured, and can be any of thefollowing:Embedded Trace Macrocell (ETM)Select this if you want to capture trace from the ETM.Embedded Trace Buffer (ETB)Select this if you want to capture trace from an ETB. You must also selectEmbedded Trace Macrocell (ETM).Vector Floating Point (VFP)Select this to use VFP, if supported.Vector Floating Point v3 (VFPv3)Select this to use VFPv3, if supported.Vector Floating Point v3-D16 (VFPv3-D16)Select this to use VFPv3-D16, if supported.NEON SIMD Extensions (Neon)Select this to use NEON, if supported.ARM DUI 0498F Copyright © 2010-2012 ARM. All rights reserved. 5-21ID021112Non-Confidential