ARM DS-5 Using the Debug Hardware Configuration Utilities

Configuring network settings for your debug hardware unit• Default Gateway• Subnet Mask.c. Continue at step 9.7. If you are using DHCP, select DHCP.8. Enter the hostname in the Host Name field. This must contain only the alphanumericcharacters (A-Z, a-z, and 0-9) and the - character, and must be no more than 255 characterslong.9. Select the required Ethernet Type:• if you know the type of network that you are using, select that type• otherwise, select Auto-Detect.10. Click Configure.The debug hardware unit restarts. During the restart, the unit is not present in the list.When the unit has restarted, it re-appears in the list of units with the new network settings.NoteIf the debug hardware unit is using DHCP, the list of units might display its IP Addressas 127.0.0.2. This is a dummy address that the debug hardware unit uses when it fails toobtain an IP address from the DHCP server.The list of units shows the correct address if the DHCP server has assigned it.3.7.3 See alsoTasks• Starting the debug hardware configuration utilities on page 2-3• Scanning for available debug hardware units on page 2-5• Determining the correct network settings on page 3-3• Troubleshooting on page 3-13• Configuring the network settings for a debug hardware unit on page 3-8• Chapter 10 Troubleshooting your debug hardware unit.Concepts• About configuring network settings on page 3-2.Reference• The Configure Debug Hardware unit dialog box on page 3-4• The Configure new Debug Hardware unit dialog box on page 3-6.ARM DUI 0498F Copyright © 2010-2012 ARM. All rights reserved. 3-11ID021112Non-Confidential