ARM DS-5 Using the Debug Hardware Configuration Utilities

Configuring debug hardware for GDB9.20 rviload command syntaxrviload enables you to load a given binary file onto the target board through a specified debughardware unit.9.20.1 Syntaxrviload [options]... address:file [address:file]...address:file A raw binary file file to be loaded at the target memory address address inhexadecimal.--autoconfig=DELAYAutoconfigure the scan chain and then wait the number of seconds specified byDELAY.Option synonym: -a DELAY--checkCheck memory as it is being written.Option synonym: -c--devnum=DEVNUMThe JTAG scan chain device number (default 1). Device 0 refers to the debughardware unit, so you can only specify devices greater than 0.Option synonym: -d DEVNUM--help--host=HOST--jtagclockDisplay the command help.Option synonym: -hThe host IP address/name of the debug hardware unit.Option synonym: -H HOSTThe JTAG clock speed in Hz, 0==‘RTCK’ (default 10MHz).Option synonym: -s--jump=JUMPTOStart executing from this (hex) address after loading.Option synonym: -j JUMPTO--dccmode=MODEEnable debug communications in the particular MODE, and must be one of thefollowing:DCC Raw DCC through client. Raw (unprocessed) data exactly as it exitedthe DCC register on the target, and is fed to the client.DCP Raw DCC through TCP/IP port range from 5000. Raw data fed toTCP/IP port in the port range specified.VEC Virtual Ethernet/TTY with tty channel through client.VEP Virtual Ethernet/TTY with tty channel through port range from 5000.The DCC mode for rviload is specified by using a three-letter mode name such asVEP or VEC, whereas the DCC mode for rvigdbconfig is specified by a modenumber such as 0, 1 or 2.ARM DUI 0498F Copyright © 2010-2012 ARM. All rights reserved. 9-28ID021112Non-Confidential