ARM DS-5 Using the Debug Hardware Configuration Utilities

Configuring CoreSight systems6.10 Loading a trace association fileTo load a CoreSight trace association file:1. Open the Debug Hardware Config utility.2. Either:• connect to and configure a debug hardware connection to create a new debughardware configuration file• open an existing debug hardware configuration file.3. Click the Trace Associations... button to display the Trace Association Editor dialog box.The following figure shows an example:Figure 6-7 Trace Association Editor dialog boxThe devices shown reflect the order of those in the scan chain.4. Click Load... to display the Load RealView Associations File... dialog box.5. Locate the directory where you saved your trace association file.6. Click Open to load the file and return to the Trace Association Editor dialog box.7. Click OK to return to the Debug Hardware Config utility main window.An asterisk in a device box of the schematic diagram indicates that the device is associatedwith another device. The following figure shows that the CSETM and the Cortex-A8devices have associations:Figure 6-8 Devices with associationsARM DUI 0498F Copyright © 2010-2012 ARM. All rights reserved. 6-13ID021112Non-Confidential