INSTALLATION MANUAL RC-2B RC-3B RC-4B RC-5B RC ... - Maxon
INSTALLATION MANUAL RC-2B RC-3B RC-4B RC-5B RC ... - Maxon INSTALLATION MANUAL RC-2B RC-3B RC-4B RC-5B RC ... - Maxon
ATTACH OPTIONAL BATTERY BOX & FRAME TOVEHICLE (IF EQUIPPED) - ContinuedNOTE: Always connect fused end of power cable to battery positive (+) terminal.NOTE: To connect charge lines, refer to instructions provided with each chargeline kit.4. Connect battery cables, fusedcables, and ground cables asshown in FIG. 16-1.(GROUND CABLETO PUMP BOX OR COMMONCHASSIS GROUND)74” LG.WARNING!Remove all rings, watches and jewelry before doing any electrical work.NOTE: MAXON recommends using dielectric grease on all electrical connections.ELECTRICAL COMPONENTS - BATTERY BOX12 VOLT BATTERY CONNECTIONS(-) BATTERY CABLETO COMMONGROUNDFUSED CABLE(SEE NOTE)(FUSED CABLE TOPUMP BOX)(IN PARTS BOX)42” LG. CIRCUITBREAKER11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713CABLE10” LG.FIG. 16-1CABLE18” LG.16
ATTACH OPTIONAL BATTERY BOX & FRAME TOVEHICLE (IF EQUIPPED) - Continued!WARNINGExplosive hydrogen gas from charging batteries can accumulate in batterybox if not vented from the box. To prevent hydrogen gas from accumulating,ensure the 3 ventilation holes in battery box are not plugged or covered.VENTILATION HOLESBATTERY BOX ASSEMBLY(REAR VIEW SHOWN)FIG. 17-111921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-771317
- Page 1 and 2: M-90-1REV. HOCTOBER 2012INSTALLATIO
- Page 3 and 4: Comply with the following WARNINGS
- Page 5 and 6: UNIT AS SHIPPEDDo not remove stands
- Page 7 and 8: INSTALLATION OF UNIT - ContinuedCor
- Page 9 and 10: INSTALLATION OF UNIT - ContinuedTyp
- Page 11 and 12: WELDING TO FLATBEDThe column assemb
- Page 13 and 14: ATTACH OPTIONAL BATTERY BOX & FRAME
- Page 15: ATTACH OPTIONAL BATTERY BOX & FRAME
- Page 19 and 20: POWER PACK INSTALLATIONTRUCK BODIES
- Page 21 and 22: POWER PACK INSTALLATION - Continued
- Page 23 and 24: PUMP WIRING CAM CLOSERTOGGLESWITCH1
- Page 25 and 26: ADD HYDRAULIC FLUIDCAUTIONKeep dirt
- Page 27 and 28: FINAL ADJUSTMENTSFill the system wi
- Page 29 and 30: ATTACH DECALSNOTE: Ensure there is
- Page 31 and 32: OPTIONSRCT LIGHT INSTALLATIONALL RC
- Page 33 and 34: OPTIONSHAND PUMP OPTION FOR CAM CLO
- Page 35 and 36: RECOMMENDED LIFTGATE POWER CONFIGUR
- Page 37 and 38: FIXED RAMP INSTALLATION, 12”Lower
- Page 39 and 40: HINGED RAMP INSTALLATION (STEEL)7/8
ATTACH OPTIONAL BATTERY BOX & FRAME TOVEHICLE (IF EQUIPPED) - Continued!WARNINGExplosive hydrogen gas from charging batteries can accumulate in batterybox if not vented from the box. To prevent hydrogen gas from accumulating,ensure the 3 ventilation holes in battery box are not plugged or covered.VENTILATION HOLESBATTERY BOX ASSEMBLY(REAR VIEW SHOWN)FIG. 17-111921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-771317