SAM4s ER-900 series Operators Manual.pdf

Memory Allocation ProgramOnce you have determined the memory variables you wish to set, you can set them in thememory allocation program. If you attempt to allocate more options than memory, themessage “MEMORY ALLOCATION SIZE OVER” will print on the receipt and journal.Setting memory allocation will require some trial and error; the register will not allow overallocation.1. Turn the control lock to the S position.2. To Allocate Memory, enter 6 0 and press the SUBTL key.60 SUBTL3. Refer to the chart below and enter a digit to represent allocated area and press theX/TIME key.X Allocated AreaXX/TIME4. Enter the desiredallocation.Note for the CHECKTYPE entry: enter 0for soft check or enter 1for hard check.1 PLU2 CLERK3 GROUP4 CHECK#5 SOFT CHECK LINES6 CHECK TYPE : Hard(1), Soft(0)7 # of PRICE LEVELS8 MIX & MATCH9 ELECTRONIC JOURNAL LINESCASH5. Repeat from step 3 to allocate another area, or press the CASH key to finalize theprogram. If the allocation is accepted, the printer will print the new allocation. Ifthe allocation is not accepted, the message “ALLOCATION OVER” will display.CASHSAM4s ER-900 Series Operator's & Programming Manual v.1.3 S-Mode Programming • 99