SAM4s ER-900 series Operators Manual.pdf

Receipt on RequestIf a customer requests a receipt after a sale has been finalized, a second depression of theCASH key will issue a complete buffered receipt. (See option #6 in “System OptionProgramming” on page 137 and option #24 in “Print Option Programming” on page 145.)Note: A maximum of approximately 224 items may be registered in one sale.Training ModeClerk InterruptA training mode is available so that you can operate the cash register without updating totalsand counters. Note the following conditions:The receipt and journal print the message "TRAINING MODE BEGIN" whentraining mode is activated. (See option #13 in “Print Option Programming” onpage 145.)The receipt and journal print the message "TRAINING MODE END" whentraining mode is exited.The message "TRAINING MODE" prints on each receipt printed while trainingmode is active.The total and counter on the financial report labeled "TRAIN TTL" is updated withthe net amount of each training transaction.To Enter Training Mode Set system option #23 to a value of 1. See "System Option Programming".To Exit Training Mode Set system option #23 to a value of 0. See "System Option Programming".Clerk interrupt allows you to temporarily suspend a transaction in progress by allowing a newclerk to sign on and register a new transaction. After the new transaction is complete, theoriginal clerk can sign on, the suspended transaction is recalled and may be completed.You must select either check (table) tracking or clerk interrupt. You cannot use clerkinterrupt with a check tracking system.To Enable Clerk Interrupt1. Program Clerk Secret Code2. Set system option #2 to a value of 1. See "System Option Programming".3. Set system option #26 to a value of 1. See "System Option Programming".64 • Operations SAM4s ER-900 Series Operator's & Programming Manual v.1.3