SAM4s ER-900 series Operators Manual.pdf

Dial In Load/Dial Out LoadThese functions apply only to legacy DataTran equipment. Perform if instructed by Datacapsupport. You will be required to enter the phone number and terminal I.D.Z-Mode: Enter 508, press SBTL (Dial In Load)Z-Mode: Enter 509, press SBTL (Dial Out Load)DataTran NoLoad/AutoLoad Notes/TwinTranNoLoadParameters managed at the processor host, not in the DataTran. For installation, changes,exchanges, call the processor, tell them the unique “mac” id, run tests and begin operations.AutoLoadParameters managed on PSCS, Datacap’s web-based load system. Parameters aredownloaded to the DataTran upon first use and for reloads on demand.TwinTranWhen a TwinTran is first installed, the dealer must do a Dial Out Load through the IPconnection. If, for any reason, the internet is not available, the device cannot be loaded. If itis being installed at a location where the Internet is not currently operational and the customerwants to use the dial out method for approvals, the procedure below must be done at alocation where the internet is working.To load a TwinTran using a Sam4s register;With the TwinTran connected to the register and an active Ethernet line, enter into the DialOut mode. At the Phone number field enter the number “1”. If the register uses the codeentry method for alpha characters enter the 3 digit code (049). At the Enter ID prompt, enterthe serial number of the TwinTran. Select Tone phone connection. The TwinTran will callDataCaps host PC and load itself. This takes approximately 20 seconds. After the TwinTran isloaded, one successful credit transaction must be done. After that the unit can be connected asthe customer wishes.SAM4s ER-900 Series Operator's & Programming Manual v.1.3 Integrated Payment Appendix • 227