SAM4s ER-900 series Operators Manual.pdf

Program 300 - PLU Descriptor ProgrammingProgram descriptors by typing descriptors on the alpha keyboard overlay or byentering three digit alpha character codes. To enter descriptors by three digit alphacharacter codes you must set system option #25 (See “System Option Programming” onpage 137).Note: You can program descriptors up to 18 characters, however only the first 16 willappear on the display.1. Turn the control lock to the PGM position2. To begin the program, enter 3 0 0, press the SUBTL key.3 0 0 SUBTL3. Select the PLU you wish to program in one of the following ways: Press a PLU key on the keyboard or scan the item.PLUEnter the number of the PLU (up to 15 digits) and press the PLU key.PLU4. If you are programming using an alpha keyboard overlay, type up to 18descriptors on the overlay and press the X/TIME key.Type up to 18descriptor keysX/TIMEIf you are programming using descriptor codes, enter up to 18 three-charactercodes and press the X/TIME key. (See “Descriptor Code Chart” on page 133.)Enter up to 18 threecharactercodesX/TIME5. To program additional PLUs, repeat from step 3, or press the CASH key tofinalize the program.CASHSAM4s ER-900 Series Operator's & Programming Manual v.1.3 P-Mode Programming • 131