Reflex - Coral Instal

Diaphragm Expansion VesselsDiaphragm Expansion VesselsReflex SReflex S in a solar heating applicationNotes for the installerReflex S• Because of the low temperature load, the circulating pump andReflex S are located in the collector return. This means that theexpansion vessel must be installed on the pressure side of thecirculating pump. The circulating pump pressure must thereforebe considered when calculating the pre-set pressure p0.• There is no need to install the Reflex 'V in-line vessel' wherethe maximum possible temperature load for the expansionvessel is 70 °C.ReflexIn-line vesselØ D• For solar, heating and cooling water systems• For up to 50 % addition of anti-freeze• With threaded connections• Diaphragm in accordance with DIN EN 13831, perm.operating temperature 70 °C• Approval in accordance with the Pressure EquipmentDirective 97/23/EC• 33 litres with suspension brackets, from 50 litres with feetHØ DA20 – 33 litresHØ D50 – 250 litreshHh300 – 600 litres10 barType10 bar/120 °CArticle no.Grey WhiteUnit price€MaterialgroupPUWeightkgØ DmmHmmhmmAPre-setpressurebarS 2 8707700 – 31.30 14 280 1.0 132 260 – G ¾ 0.5S 8 8703900 9702600 57.40 14 96 2.5 206 316 – G ¾ 1.5S 12 8704000 9702700 61.70 14 72 2.5 280 300 – G ¾ 1.5S 18 8704100 9702800 67.30 14 56 3.2 280 374 – G ¾ 1.5S 25 8704200 9702900 83.90 14 42 4.5 280 496 – G ¾ 1.5S 33 8706200 9706300 115.00 14 24 6.3 354 455 – G ¾ 1.5S 50 8209500 – 260.00 19 20 9.5 409 469 158 R ¾ 3.0S 80 8210300 – 363.00 19 12 14.6 480 538 166 R 1 3.0S 100 8210500 – 395.00 19 10 15.5 480 644 166 R 1 3.0S 140 8211500 – 628.00 19 6 17.4 480 941 210 R 1 3.0S 200 8213400 – 662.00 19 – 35.6 634 758 205 R 1 3.0S 250 8214400 – 771.00 19 – 40.8 634 888 205 R 1 3.0S 300 8215400 – 850.00 19 – 47.0 634 1092 235 R 1 3.0S 400 8219000 – 1,210.00 19 – 61.0 740 1102 245 R 1 3.0S 500 8219100 – 1,300.00 19 – 72.0 740 1321 245 R 1 3.0S 600 8219200 – 1,596.00 19 – 87.0 740 1559 245 R 1 3.0Vn Nominal volume/litres10