JP-E78 Printing Ink | Material Safety Data Sheet : Hitachi America, Ltd.

SECTION IV - FIRST AID MEASURESORAL INGESTIONEYE CONTACTSKIN CONTACTINHALATIONDo not induce vomiting unless directed to do so by medical personnel. Seek immediate medical attention.Flush with water for 15 minutes and seek medical attention.Wash with soap and water. Wash contaminated clothing before reuse. Seek immediate medical attention.Remove to fresh air, if not breathing, give artificial respiration and seek medical attention.SECTION V - FIREFIGHTING MEASURESEXTINGUISHING MEDIAHAZARDOUS COMBUSTIONPRODUCTSFIRE FIGHTING PROCEDURESAlcohol Resistant foam or dry chemicalCarbon Monoxide, Carbon DioxideWear self-contained breathing apparatus with full facepieceoperated in the positive pressure demand mode.SECTION VI - ACCIDENTAL RELEASE MEASURESKeep away all sources of ignition from spill. If spill is indoors, ventilate areas of spill and soak up the spill with absorbent material. Do not let spilled or leakingmaterial enter watercourse.SECTION VII - HANDLING AND STORAGEHANDLINGSTORAGEAvoid contact with eyes. Wash hands thoroughly with soap and water after handling. Utilize proper grounding with containers of material.Protect from freezing. Overheating may cause container to rupture. Covered storage in a cool, dry place out of direct sunlight ispreferable. Keep container tightly sealed until ready for use. Store away from ignition sources.SECTION VIII - EXPOSURE CONTROLS / PERSONAL PROTECTIONRESPIRATORY PROTECTIONVENTILATIONPROTECTIVE GLOVESEYE PROTECTIONOTHER PROTECTIVE EQUIPMENTOCCUPATIONAL EXPOSURE LIMITS:If workplace exposure limit(s) of product or any other component is exceeded, a NIOSH/OSHA approved respirator is advised. (Seeyour safety equipment supplier for specific details.)Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below PEL/ TLV.Wear chemical resistant gloves. (Consult your safety equipment supplier.)Wear chemical splash goggles in compliance with OSHA regulations. However, OSHA regulations also permit other types of safetyglasses.Wear impervious clothing and boots to prevent prolonged exposure.INGREDIENT ACGIH TLV* OSHA PEL*Ethanol 1000 1000Acetone 750 750Propylene Glycol Not Established Not EstablishedAmmonium Hydroxide 35 35FD&C Red #3 Not Established Not EstablishedSECTION IX - PHYSICAL & CHEMICAL PROPERTIESPHYSICAL STATELiquidCOLORRedODORSolvent odorBOILING RANGE~ 78° CMELTING RANGE~ - 130° CSPECIFIC GRAVITY (WATER=1) 0.849DENSITY (lbs / gal) 7.08EVAPORATION RATE (N-BUTYL ACETATE=1) ~ 1.9PERCENT VOLATILE BY VOLUME (%) 77.5%VAPOR PRESSURE~ 44 mm of Hg @ 20° CVAPOR DENSITY (AIR=1)Greater than airFLASH POINT (TCC)21° CAUTO IGNITION TEMPERATURE~ 422° CUPPER FLAMMABLE LIMIT (%BY VOL.) 19LOWER FLAMMABLE LIMIT (%BY VOL.) 3.3SOLUBILITY IN WATERMiscibleSOLUBILITY IN ORGANIC SOLVENTSMisciblePHNot ApplicablePage 2 of 4

SECTION X - STABILITY & REACIVITYCONDITION OF INSTABILITYCONDITIONS OF REACTIVITYINCOMPATIBILITYHAZARDOUS DECOMPOSITION PRODUCTSEXPLOSION DATA (SENSITIVE TO MECHANICAL IMPACT)EXPLOSION DATA (SENSITIVE TO STATIC DISCHARGE)None KnownNot applicableStrong oxidizing agentsCarbon Monoxide, Carbon DioxideNoYesSECTION XI - TOXICOLOGICAL INFORMATIONINGREDIENTEthanolAcetonePropylene GlycolAmmonium HydroxideFD&C Red #3TOXICOLOGICAL INFORMATION**LD 50 Oral (rat) - 7060 mg / kgLC 50 Inhalation (rat) - 20,000 ppm / 10 hrLD 50 Intraperitoneal (rat) - 3750 mg / kgLD 50 Intravenous (rat) - 1440 mg / kgLD Lo Oral (dog) - 5500 mg / kgLD Lo Subcutaneous (dog) - 6000 mg / kgLD 50 Intravenous (rat) 5500 mg / kgLD 50 Oral (rat) - 5800 mg / kgLC 50 Inhalation (rat) - 50,000 mg / m 3 / 8 hrLD Lo Oral (dog) - 8 g / kgLD 50 Oral (rabbit) - 5340 mg / kgLD 50 Skin (rabbit) - 20 g / kgLD 50 Oral (rat) - 20 g / kgLD 50 Intraperitoneal (rat) - 6660 mg / kgLD 50 Subcutaneous (rat) - 22,500 mg / kgLD 50 Intravenous (rat) - 6423 mg / kgLD 50 Intramuscular (rat) - 14 g / kgLD 50 Oral (rat) - 350 mg / kgLD Lo Oral (cat) - 750 mg / kgLD Lo Intravenous (rabbit) - 10 mg / kgLD 50 Oral (rat) - 1840 mg / kgLD 50 Intravenous (rat) - 200 mg / kgLD 50 Oral (mouse) - 1264 mg / kgLD 50 Intravenous (mouse) - 370 mg / kgSECTION XII - ECOLOGICAL INFORMATIONECOTOXICITYPERSISTANCE / DEGRADABILITYHEAVY METALSNot AvailableNot AvailableConcentration of lead, mercury, cadmium and hexavalent chromium [Cr(VI)] < 100 ppmNo other ecological information is available for this product.SECTION XIII - DISPOSAL CONSIDERATIONSAbsorb in vermiculite, floor absorbent or other non-combustible absorbent material and dispose in licensed facility. Observe all federal, state and localregulations.SECTION XIV - TRANSPORT INFORMATIONDOT / TDG UN NUMBER & PROPER SHIPPING NAMEUN1210 PRINTING INKDOT / TDG HAZARD CLASS 3DOT / TDG LABELPACKING GROUPFLAMMABLE LIQUIDEMERGENCY RESPONSE GUIDEBOOK NUMBER 129IIPage 3 of 4

SECTION XV - REGULATORY INFORMATIONTSCACERCLAAll chemicals used are listed on the TSCA Inventory.The following product(s) is (are) listed by CERCLA:Acetone (3 - 7%)Ammonium Hydroxide (0.5 - 1.5%)SARA 313 The following product(s) is (are) listed on SARA 313:California Prop 65InternationalRegulationsSECTION XVI - OTHER INFORMATIONISSUE DATE March 2007REVISION NUMBER 1Ammonium Hydroxide (0.5 - 1.5%)This product contains the following ingredients that the State of California has found to cause cancer, birth defects,or other reproductive harm, which requires a warning under the statute:noneThe components of this product are listed on the chemical inventories of the following countries:Australia, Canada, Europe (EINECS), Japan, Korea, United KingdomSUPERCEDESPREPARED BYn/aChris Jordan,Product SpecialistDISCLAIMEREvery effort has been made to ensure that the information in this MSDS is accurate and as complete as reasonably possible and of course alldata herein are given in good faith. However, all information is furnished without warranty of any kind, and Hitachi America, Ltd. expresslynegates any warranty of accuracy, expressed or implied; and Hitachi America, Ltd. assumes no responsibility for personal injury or damage toproperty to customers, vendors, or third parties if any information herein proves to be incorrect in any respect. Purchasers are encouraged tomake independent determination of suitability and completeness of information from all sources to assure proper use and compatibility ofproduct.*NIOSH Publication #94-116**Sax’s Dangerous Properties of Industrial Mtls. 11th Ed.Page 4 of 4