100 mm

ELECTRO-TECHNOLOGY FOR INDUSTRYDimensions368 Ø 18116530 303 holes Ø 7Alarm tone table BExCA 110-05DStage Tone & frequency description Tone length1 alternating tone 800 Hz / 1000 Hz, alternation every 0.25 s 4 cycles2 slow whoop 500-1200 Hz, duration 3 s, gap 0.5 s 2 cycles3 sawtooth 1200 Hz / 500 Hz @ 1Hz –DIN / PFEER P.T.A.P. 4 cycles4 alternating tone 544 Hz for 100 ms, 440 Hz for 400 ms – NF S 32.001 4 cycles5 continuous tone 1000 Hz, toxic gas alarm 2 cycles6 simulated bell 2 cycles7 interrupted tone 1000 Hz, signal 1 s, gap 1 s, general alarm 3 cycles8 Australian alert 420 Hz with 0.625 s gap 4 cycles9 Australian evacuation alarm 500 Hz / 1200 Hz, duration 3.75 s, gap 0.25 s 2 cycles10 no tone – 0.5 s gapOrdering detailsArticle numbers BExCL 15-05DLens colour Type 230 V AC 24 V DCred 8 Ω 320 91 10 5 910 320 91 80 5 910red 16 Ω 320 91 10 5 911 320 91 80 5 911red 100 V transformer 320 91 10 5 912 320 91 80 5 912Article numbers BExCA 110-05DLens colour Rated voltage 230 V AC 115 V AC 24 V DCred 320 71 10 5 000 320 71 15 5 000 320 71 80 5 000Article numbers for other colours and voltages on requestOptions / accessoriesVisual-audibleEx signaling devicesGOSTManufacturer’s declarationWe hereby declare that the explosion-protected means of alarm with the type designationBExCL 150-05 D, BExCA 110-05Dhas been developed and manufactured in accordance with section 5.1.2 of EN 50014.This declaration is based on compliance with the following regulations and standards:94/9/EGCE conformityEN 50014 Electrical equipment for areas at risk of explosions – General requirementsEN 50018 Pressure-resistant encapsulation ‘d’EN 50281-1-1 Electrical equipment for use in areas with combustible dustFurther technical information can be found on our website at www.pfannenberg.com239