ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 14: Receiver, Battery and Scale Accessories Step 7Use five #2 x 3/8-inch sheet metal screws to attach therear canopy to the fuselage and stabilizer. There are twoscrews on either side of the fuselage, two on each sidethat go into the stabilizer, and one positioned at the frontof the canopy (as referenced from the fuselage). Apply afew drops of thin CA to each of the holes to harden thesurrounding wood. Step 8Use hobby scissors to trim the rear gun mount. UseRC-56 canopy glue to secure the mount to the end of thefuselage. Use tape to hold the mount in position until theglue fully cures. Step 9Install the guns by drilling holes in the appropriatelocations. Glue the guns using RC-56 canopy glue.Note: Make sure to pre-drill for the screwsusing a drill and 1/16-inch (1.5mm) drillbit to prevent damaging the canopy.Note: If you chose to permanently gluethe horizontal stabilizer to the fuselage,then the rear canopy can be glued inplace using R/C 56 canopy glue70