ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 14: Receiver, Battery and Scale AccessoriesRequired Parts• Assembled fuselage • Radio tray• Receiver• Receiver battery• Foam padding• Receiver cover• 3mm washer (4)• Canopy (nose)• Canopy (main)• Canopy (rear)• Tail gun mount • Side gun mount (2)• Side gun pod (2) • Guns (12)• Top turret• Radar dome• Tail blister• Decal sheet• Hook and loop strap • Hex wrench: 2.5mm• 3mm x 12mm machine screw (4)• 128mmx 45mm x 3mm battery tray• #2 x 3/8-inch sheet metal screw (4)The quantity of the following two items will depend onreceiver used.• Y-harness (2)• 6-inch (153mm) servo extension (2)Required Tools and Adhesives• Drill• RC-56 canopy glue• Phillips screwdriver • Masking tape• Drill bit: 1/16-inch (1.5mm) • 30-minute epoxy• 1/4-inch (4mm) foam Step 1Wrap the receiver in foam and plug any necessaryextensions and Y-harnesses into the appropriate channels.Secure the receiver to the radio plate using a hook andloop strap. Step 2Secure the radio plate in the fuselage using four3mm x 12mm machine screws and four 3mm washers.Plug the elevator and steering servos into the receiver atthis time as well.Note: Apply threadlock to the3mm x 12mm machine screws sothey will not vibrate loose in flight.68