ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 13: Tail Section Installation Step 8Mix up 1/2-ounce (15Ml) of 30-minute epoxy. Apply theepoxy to the exposed wood of the stabilizer. The stabilizershould then be bolted into place. Refer to Step 4 fordetails Use paper towels and rubbing alcohol to removeany excess epoxy from the fuselage and stabilizer. Allowthe epoxy to fully cure before proceeding. Step 10Use a drill and 1/16-inch (1.5mm) drill bit to drill thelocations for the servo mounting screws. Step 9Position the servo in the opening with the servo armfacing the front of the fuselage. Mark the locations for theservo mounting screws using a felt-tipped pen. Step 11Apply a few drops of thin CA to each of the holes drilledin the previous step. This will help harden the wood,making the screws more secure in their placement.66