ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 12: Rudder and Servo InstallationRequired Parts• Stabilizer • Nylon clevis (2)• Pushrod connector (2) • Control horn (2)• Servo w/hardware (2)• Rudder (right and left)• Rudder linkage, 2-inch (51mm) (2)• 2-56 x 7/8-inch machine screw (6)• #2 x 3/8-inch sheet metal screw (8) Step 3Use a drill and 1/16-inch (1.5mm) drill bit to drill fourholes, approximately 1/8-inch (3mm) from the corners ofthe servo cover.Required Tools and Adhesives• Drill• Thin CA• Phillips screwdriver • Long servo arm• Hobby knife• Felt-tipped pen• Pliers• Drill bit: 1/16-inch (1.5mm), 5/32-inch (2mm) Step 1Mounting the rudder servo follows the same procedureas mounting the aileron servo (Section 2: Aileron ServoInstallation, Steps 1 through 7.) Use a 180 degree servoarm and remove the excess arm using side cutters. Simplyfollow those steps to mount the rudder servo to the rudderservo cover. Step 4Apply a few drops of thin CA to each of the holes toharden the surrounding wood. Step 2Route the servo lead to the nearest hole in the center ofthe stabilizer using the installed string. Position the coverso the servo arm is toward the tip of the stabilizer.59