ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

More documents

Recommendations

Info

Section 10: Engine Nacelle Installation Step 8Attach the engine nacelle to the wing using two 8-32 x1-inch socket head bolts and two #8 washers. Step 10Use a sharp hobby knife to remove a 1/8-inch (3mm) widestrip to the inside of the line drawn in the previous step.Note: Use threadlock on all screws to keepthem from coming loose during flight. Step 9Position the nacelle top cover on the wing, aligning it withthe front and rear of the engine nacelle. Trace the outlineof the nacelle top cover on the wing with a felt-tipped pen. Step 11Use 30-minute epoxy to glue the nacelle top cover tothe wing. Use tape to hold the nacelle cover while theepoxy cures. Step 12Repeat Steps 1 through 11 to install the remaining enginenacelle and nacelle top cover on the wing.56
Section 11: Wing InstallationRequired Parts• Assembled wing panel (right and left)• Wing tube•Wing bolt plate• 1/4-inch washer (2)• Battery tray (electric only)• Hook and loop strap (electrtic only)• 1/4-20 x 1 1 / 2-inch socket head bolt (2) Step 3Hold the wing bolt plate centered on the wing centersection. Use a felt-tipped pen to mark the location for oneof the holes in the plate.Required Tools and Adhesives• Felt-tipped pen•Drill• Ball driver: 3/16-inch• Drill bit: 1/4-inch (6mm) Step 1Slide the wing tube into one of the wing panels. Step 4Use a 1/4-inch (6mm) drill bit to make a hole in the plate.Position the plate back on the wing. Step 2Slide the remaining panel onto the wing tube. The panelsshould fit tight against each other.57
Page 1:
B-25 Mitchell ARFAssembly manualSpe
Page 5 and 6: Recommended JR, JR SPORT and Spektr
Page 7: Contents of Kit and Replacement Par
Page 10 and 11: Safety, Precautions, and WarningsTh
Page 12 and 13: Section 1: Hinging the Flaps and Ai
Page 14 and 15: Section 2: Aileron Servo Installati
Page 20: Section 3: Fixed Flap Linkage Insta
Page 23 and 24: Section 4: Operation Flap Linkage I
Page 25 and 26: Section 4: Operation Flap Linkage I
Page 27 and 28: Section 5: Electric Motor Installat
Page 29: Section 5: Electric Motor Installat
Page 32 and 33: Section 6: Glow Engine Installation
Page 40 and 41: Section 7: Fixed Landing Gear Insta
Page 42 and 43: Section 7: Fixed Landing Gear Insta
Page 44 and 45: Section 8: Retractable Landing Gear
Page 52 and 53: Section 9: Retract Valve and Hardwa
Page 54 and 55: Section 10: Engine Nacelle Installa
Page 58 and 59: Section 11: Wing Installation Step
Page 60 and 61: Section 12: Rudder and Servo Instal
Page 62 and 63: Section 12: Rudder and Servo Instal
Page 64 and 65: Section 13: Tail Section Installati
Page 66 and 67: Section 13: Tail Section Installati
Page 68 and 69: Section 14: Receiver, Battery and S
Page 70: Section 14: Receiver, Battery and S
Page 73 and 74: Control ThrowsThe amount of control
Page 75 and 76: Pre-FlightCharge both the transmitt
Page 77 and 78: Engine OutA concern that most pilot
Page 79 and 80: 2007 Official AMANational Model Air
show all

ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Create successful ePaper yourself

Delete template?

Save as template?