ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 10: Engine Nacelle Installation Step 4Use 30-minute epoxy to glue the plate on the wing. Step 6Secure a 12-inch (305mm) servo extension to the throttle(or speed control) lead. Tie the string around the end ofthe extension as shown. Step 5Use 30-minute epoxy to glue the two 1 1 / 8x 1/4-inch(28mm x 4mm) dowels into the hole in the leading edgeof the wing for the engine nacelle.Note: If you have installed retracts,you will need to tie the string to theair lines as well in this step. Step 7Carefully pull the servo extensions through the wing usingthe string. The engine nacelle will need to be close tothe wing for the extension from the throttle servo (speedcontrol) to reach the opening in the wing. Once theextensions have been pulled through the wing, use tape tokeep them from falling back into the wing.55