ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 10: Engine Nacelle InstallationRequired Parts• Assembled wing panel (right and left)• Assembled engine nacelle (right and left)• 8-32 blind nut (4) • #8 washer (4)• Nacelle support plate (2)• Nacelle cover (right and left)• 8-32 x 1-inch socket head screw (4)• 1 1 / 8x 1/4-inch (28mm x 4mm) dowel (4) Step 2Place the nacelle support plate over the holes in thetrailing edge of the wing and trace the outline of the plateonto the wing.Required Tools and Adhesives• 30-minute epoxy• Hobby knife• Masking tape• Ball driver: 9/64-inch Step 1Use a short 8-32 socket head bolt and 9/64-inch balldriver to draw the two blind nuts up into the enginenacelle mounting plate. Step 3Use a sharp hobby knife to remove the covering where theplate will be secured to the wing.54