ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 8: Retractable Landing Gear Installation Step 14Center the nose gear and steering servo. Thread a clevison the threaded rigging couplers and attach them to thesteering servo arm. Make sure to cut a 1/4-inch (4mm)piece of heat shrink tubing for each of the clevises andslide them into position. Mark where the cable crosses thehole in the fastener. Step 16Use a rotary tool and sanding drum to remove the areaof the nose gear cover to allow the nose wheel strut andwheel to pass through. Step 15Repeat the crimping process, aligning the marks madeon the cable with the hole in the fastener. Cut any excesscable using side cutters.Note: Use the same color air line forup and then use the same other colorfor down on each of the three retractunits. This will allow you to follow theincluded air line diagram from Robart.Note: Use threadlock on all screws to keepthem from coming loose during flight.48