ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 7: Fixed Landing Gear Installation Step 17Connect the pull-pull cable to the steering arm usingtwo crimps. Pass the cable through a crimp, throughthe fasteners then back through the crimp. Use crimpingpliers to secure the crimps on the wire. Step 19Repeat the crimping process, aligning the marks madeon the cable with the hole in the fastener. Cut any excesscable using side cutters. Step 18Center the nose gear and steering servo. Thread a clevison the threaded rigging couplers and attach them to thesteering servo arm. Make sure to cut a 1/4-inch (4mm)piece of heat shrink tubing for each of the clevises andslide them into position. Mark where the cable crosses thehole in the fastener. Step 20Place the doors in position and drill a 1/16-inch(1.5mm) hole 1/8-inch (3mm) from the corners of thesteering servo and nose gear doors. Remove doors andapply a few drops of thin CA into each hole of the doorsand the mounting tabs in the fuselage to harden thesurrounding wood. Step 21Secure the doors over the steering servo and nose gearwith eight #2 x 3/8-inch sheet metal screws at each cornerof the doors.43