ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

More documents

Recommendations

Info

Section 6: Glow Engine Installation Step 16Apply a few drops of thin CA into each hole to harden thesurrounding wood. You may need to run the drill bit backthrough the holes after applying the CA. Step 18Electronically move the throttle servo to low, andphysically close the carburetor. Secure the position ofthe wire using a 2mm setscrew and the included 1.5mmhex wrench. Step 17Mount the servo in the engine nacelle as shown.Note: Use threadlock on the setscrewto prevent it from vibrating loose. Step 19Use side cutters to trim the pushrod wire so only 1/2-inch(12mm) extends beyond the rear of the pushrod connector.34
Section 6: Glow Engine Installation Step 20Attach the muffler to the engine following the instructionsprovided with the engine. Step 22Insert the tank into the fuselage, guiding the tubes thoughthe opening in the center of the firewall. Step 21Carefully inspect the fuel tank to determine which tube isattached to the clunk and which is attached to the vent.The vent will face toward the top of the tank. Step 23Secure the tank using the 1/4 x 1/4-inch stick providedwith the model. Cut the stick in half so you have a piecefor both fuel tanks.35
Page 1: B-25 Mitchell ARFAssembly manualSpe
Page 5 and 6: Recommended JR, JR SPORT and Spektr
Page 7: Contents of Kit and Replacement Par
Page 10 and 11: Safety, Precautions, and WarningsTh
Page 12 and 13: Section 1: Hinging the Flaps and Ai
Page 14 and 15: Section 2: Aileron Servo Installati
Page 20: Section 3: Fixed Flap Linkage Insta
Page 23 and 24: Section 4: Operation Flap Linkage I
Page 25 and 26: Section 4: Operation Flap Linkage I
Page 27 and 28: Section 5: Electric Motor Installat
Page 29: Section 5: Electric Motor Installat
Page 32 and 33: Section 6: Glow Engine Installation
Page 40 and 41: Section 7: Fixed Landing Gear Insta
Page 42 and 43: Section 7: Fixed Landing Gear Insta
Page 44 and 45: Section 8: Retractable Landing Gear
Page 52 and 53: Section 9: Retract Valve and Hardwa
Page 54 and 55: Section 10: Engine Nacelle Installa
Page 56 and 57: Section 10: Engine Nacelle Installa
Page 58 and 59: Section 11: Wing Installation Step
Page 60 and 61: Section 12: Rudder and Servo Instal
Page 62 and 63: Section 12: Rudder and Servo Instal
Page 64 and 65: Section 13: Tail Section Installati
Page 66 and 67: Section 13: Tail Section Installati
Page 68 and 69: Section 14: Receiver, Battery and S
Page 70: Section 14: Receiver, Battery and S
Page 73 and 74: Control ThrowsThe amount of control
Page 75 and 76: Pre-FlightCharge both the transmitt
Page 77 and 78: Engine OutA concern that most pilot
Page 79 and 80: 2007 Official AMANational Model Air

ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?