ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 5: Electric Motor Installation Step 8Use hobby scissors and a rotary tool with a small sandingdrum to make a round opening in the dummy engine forthe motor shaft. Step 10Use 30-minute epoxy to glue the dummy engine insidethe cowling. Step 9Use a sharp hobby knife to remove the material betweenthe dummy cylinder heads to allow cooling air to passthrough the dummy engine and over the motor. Step 11Tape four pieces of card stock to the engine nacelle. Alignthe card stock so the ends align with the front edge ofthe firewall. Align the sides of the card stock so they arecentered on the raised areas of the nacelle.28