ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 5: Electric Motor Installation Step 4Attach the X-mount to the motor using the hardwaresupplied with the motor. Step 6Attach the motor to the standoffs using four 8-32 x3/4-inch socket head screws. Tighten all the screwsat this time.Important: Use threadlock onany metal-to-metal fasteners. Step 5Attach the four 1 3 / 4-inch (45mm) motor standoffs to thefirewall to the engine nacelle using four 8-32 x 3/4-inchsocket head screws and four #8 washers. Leave thescrews slightly loose in case the standoffs need to bemoved slightly.Note: Use threadlock on all eight of the8-32 screws required to mount the motor. Step 7Solder any necessary connector to the speed control.Connect the leads between the motor and speed control.Secure the speed controller to the motor standoffs usingdouble-sided tape and tie wraps. Route the power lead andservo lead through the hole in the center of the firewall.27