ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

More documents

Recommendations

Info

Section 4: Operation Flap Linkage Installation Step 8Cut two 1/4-inch (4mm) long pieces from the heat shrinktubing and slide it onto each of the clevises. Thread theclevises onto the flap linkage. Step 10Bend the pushrod wire 90 degrees at the mark made in theprevious step. Step 9Hold the flap so it is aligned in the centered position. Usea felt-tipped pen to mark where the pushrod crosses theservo arm. Step 11Leave the radio system on to prevent the servo fromchanging position. Use a 5/64-inch (2mm) drill bit toenlarge the outer hole in the servo arm. Attach the linkageto the servo arm using a pushrod connector.24
Section 4: Operation Flap Linkage Installation Step 12Adjust the position of the clevises so the flaps are alignedwith the trailing edge of the wing when the flap servo is inthe up position. Use the heat shrink tubing and heat gunto make sure the clevises will not become disconnectedfrom the flap control horns. Be careful not to damage thecovering. Step 13Repeat Steps 1 though 10 for the remaining flap linkage.<strong>25</strong>
Page 1: B-25 Mitchell ARFAssembly manualSpe
Page 5 and 6: Recommended JR, JR SPORT and Spektr
Page 7: Contents of Kit and Replacement Par
Page 10 and 11: Safety, Precautions, and WarningsTh
Page 12 and 13: Section 1: Hinging the Flaps and Ai
Page 14 and 15: Section 2: Aileron Servo Installati
Page 20: Section 3: Fixed Flap Linkage Insta
Page 23: Section 4: Operation Flap Linkage I
Page 27 and 28: Section 5: Electric Motor Installat
Page 29: Section 5: Electric Motor Installat
Page 32 and 33: Section 6: Glow Engine Installation
Page 40 and 41: Section 7: Fixed Landing Gear Insta
Page 42 and 43: Section 7: Fixed Landing Gear Insta
Page 44 and 45: Section 8: Retractable Landing Gear
Page 52 and 53: Section 9: Retract Valve and Hardwa
Page 54 and 55: Section 10: Engine Nacelle Installa
Page 56 and 57: Section 10: Engine Nacelle Installa
Page 58 and 59: Section 11: Wing Installation Step
Page 60 and 61: Section 12: Rudder and Servo Instal
Page 62 and 63: Section 12: Rudder and Servo Instal
Page 64 and 65: Section 13: Tail Section Installati
Page 66 and 67: Section 13: Tail Section Installati
Page 68 and 69: Section 14: Receiver, Battery and S
Page 70: Section 14: Receiver, Battery and S
Page 73 and 74: Control ThrowsThe amount of control
Page 75 and 76:
Pre-FlightCharge both the transmitt
Page 77 and 78:
Engine OutA concern that most pilot
Page 79 and 80:
2007 Official AMANational Model Air
show all

ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Create successful ePaper yourself

Delete template?

Save as template?