ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 4: Operation Flap Linkage InstallationRequired Parts• Assembled wing panel (right and left)• Servo w/hardware (2) • Flap linkage (2)• Pushrod connector (2) • Nylon clevis (4)• 1/4-inch (4mm) heat shrink tubing• Y-harnessor12-inch (305mm) servo extenstion (2) Step 2Position the flap servo in the opening. Route the servolead out of the opening where the aileron extension islocated. The horn on the servo will be toward the leadingedge of the wing. Use a felt-tipped pen to mark thelocations for the servo mounting screws.Required Tools and Adhesives• Hobby knife• Phillips screwdriver• Drill bit: 1/16-inch (1.5mm) • Thin CA• Drill Step 1Use a sharp hobby knife to remove the covering for theflap servo from the wing. Step 3Use a drill and 1/16-inch (1.5mm) drill bit to drill thelocations for the servo mounting screws.22