ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Section 2: Aileron Servo Installation Step 17Hold the aileron so it is aligned in the centered position.With the servo centered, use a felt-tipped pen to markwhere the pushrod crosses the servo arm. Step 19Use 30-minute epoxy to glue the 1 1 / 8x 5/16-inch(28mm x 8mm) wing dowel in the wing. Press thedowel into the wing and clean any excess epoxy fromthe dowel and wing. Step 18Bend the pushrod wire 90 degrees at the mark made inthe previous step. Use a pushrod connector to secure thepushrod to the servo arm. Use side cutters to remove anyexcess wire extending beyond the connector. Step 20Repeat Steps 1 though 19 for the remaining wing panel. Step 21Use 30-minute epoxy to glue the 1 1 / 8x 1/4-inch(28mm x 6mm) wing dowel in the wing. Press thedowel into the wing and clean any excess epoxy fromthe dowel and wing.19