ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

More documents

Recommendations

Info

Section 2: Aileron Servo Installation Step 14Use a drill and 5/32-inch (2mm) drill bit to drill the threemounting holes through the aileron. Step 16Attach the control horn to the aileron using three2-56 x 7/8-inch machine screws and the controlhorn backplate. Step 15Apply a few drops of thin CA into each hole to harden thesurrounding wood. You may need to run the drill bit backthrough the holes after applying the CA.18
Section 2: Aileron Servo Installation Step 17Hold the aileron so it is aligned in the centered position.With the servo centered, use a felt-tipped pen to markwhere the pushrod crosses the servo arm. Step 19Use 30-minute epoxy to glue the 1 1 / 8x 5/16-inch(28mm x 8mm) wing dowel in the wing. Press thedowel into the wing and clean any excess epoxy fromthe dowel and wing. Step 18Bend the pushrod wire 90 degrees at the mark made inthe previous step. Use a pushrod connector to secure thepushrod to the servo arm. Use side cutters to remove anyexcess wire extending beyond the connector. Step 20Repeat Steps 1 though 19 for the remaining wing panel. Step 21Use 30-minute epoxy to glue the 1 1 / 8x 1/4-inch(28mm x 6mm) wing dowel in the wing. Press thedowel into the wing and clean any excess epoxy fromthe dowel and wing.19
Page 1: B-25 Mitchell ARFAssembly manualSpe
Page 5 and 6: Recommended JR, JR SPORT and Spektr
Page 7: Contents of Kit and Replacement Par
Page 10 and 11: Safety, Precautions, and WarningsTh
Page 12 and 13: Section 1: Hinging the Flaps and Ai
Page 14 and 15: Section 2: Aileron Servo Installati
Page 16 and 17: Section 2: Aileron Servo Installati
Page 20: Section 3: Fixed Flap Linkage Insta
Page 23 and 24: Section 4: Operation Flap Linkage I
Page 25 and 26: Section 4: Operation Flap Linkage I
Page 27 and 28: Section 5: Electric Motor Installat
Page 29: Section 5: Electric Motor Installat
Page 32 and 33: Section 6: Glow Engine Installation
Page 40 and 41: Section 7: Fixed Landing Gear Insta
Page 42 and 43: Section 7: Fixed Landing Gear Insta
Page 44 and 45: Section 8: Retractable Landing Gear
Page 52 and 53: Section 9: Retract Valve and Hardwa
Page 54 and 55: Section 10: Engine Nacelle Installa
Page 56 and 57: Section 10: Engine Nacelle Installa
Page 58 and 59: Section 11: Wing Installation Step
Page 60 and 61: Section 12: Rudder and Servo Instal
Page 62 and 63: Section 12: Rudder and Servo Instal
Page 64 and 65: Section 13: Tail Section Installati
Page 66 and 67: Section 13: Tail Section Installati
Page 68 and 69:
Section 14: Receiver, Battery and S
Page 70:
Section 14: Receiver, Battery and S
Page 73 and 74:
Control ThrowsThe amount of control
Page 75 and 76:
Pre-FlightCharge both the transmitt
Page 77 and 78:
Engine OutA concern that most pilot
Page 79 and 80:
2007 Official AMANational Model Air
show all

ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?