ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

More documents

Recommendations

Info

Section 2: Aileron Servo Installation Step 8Secure an 18-inch (457mm) servo extension to the servolead for the aileron. Make sure to secure the servo leadto the extension using string or a commercially availableconnector to prevent them from becoming disconnectedinside the wing. Step 10Use a drill and 1/16-inch (1.5mm) drill bit to drill fourholes, approximately 1/8-inch (3mm) from the corners ofthe servo cover. Step 9Tie the string that has been installed inside the wingto the servo extension. Use the string to pull the servoleads through the wing and to the opening of the wingpanel near the flap servo. You will pull the flap servo leadsand the throttle servo leads with this same pull string. Step 11Use four #2 x 3/8-inch sheet metal screws to secure theservo cover to the wing.16
Section 2: Aileron Servo Installation Step 12Cut two 1/4-inch (4mm) long pieces from the heatshrink tubing and slide it onto each of the clevises.Thread a nylon clevis onto the 6-inch (152mm) aileronpushrod wire. Step 13Remove the backplate from a control horn. Connect theclevis to the horn and position the horn so the pushrodis parallel to the servo horn. Align the holes in the hornwith the hinge line. Use a felt-tipped pen to transfer thelocations for the mounting screws on the aileron.Align holeswith hinge line17
Page 1: B-25 Mitchell ARFAssembly manualSpe
Page 5 and 6: Recommended JR, JR SPORT and Spektr
Page 7: Contents of Kit and Replacement Par
Page 10 and 11: Safety, Precautions, and WarningsTh
Page 12 and 13: Section 1: Hinging the Flaps and Ai
Page 14 and 15: Section 2: Aileron Servo Installati
Page 18 and 19: Section 2: Aileron Servo Installati
Page 20: Section 3: Fixed Flap Linkage Insta
Page 23 and 24: Section 4: Operation Flap Linkage I
Page 25 and 26: Section 4: Operation Flap Linkage I
Page 27 and 28: Section 5: Electric Motor Installat
Page 29: Section 5: Electric Motor Installat
Page 32 and 33: Section 6: Glow Engine Installation
Page 40 and 41: Section 7: Fixed Landing Gear Insta
Page 42 and 43: Section 7: Fixed Landing Gear Insta
Page 44 and 45: Section 8: Retractable Landing Gear
Page 52 and 53: Section 9: Retract Valve and Hardwa
Page 54 and 55: Section 10: Engine Nacelle Installa
Page 56 and 57: Section 10: Engine Nacelle Installa
Page 58 and 59: Section 11: Wing Installation Step
Page 60 and 61: Section 12: Rudder and Servo Instal
Page 62 and 63: Section 12: Rudder and Servo Instal
Page 64 and 65: Section 13: Tail Section Installati
Page 66 and 67:
Section 13: Tail Section Installati
Page 68 and 69:
Section 14: Receiver, Battery and S
Page 70:
Section 14: Receiver, Battery and S
Page 73 and 74:
Control ThrowsThe amount of control
Page 75 and 76:
Pre-FlightCharge both the transmitt
Page 77 and 78:
Engine OutA concern that most pilot
Page 79 and 80:
2007 Official AMANational Model Air
show all

ASSEMBLY MANUAL B-25 Mitchell ARF - RC DEPOT

Create successful ePaper yourself

Delete template?

Save as template?